Deckorators Postcover Manuel d'utilisateur télécharger pdf

42” and 53” Postcover Installation Instructions

Introduction

Carefully plan your entire deck, from deck boards to rails and

stairs, before cutting your ﬁrst board or drilling your ﬁrst hole.

Account for the unique design and dimensions of Deckorators

postcovers and your chosen rail system in the planning stage.

Inventory all necessary postcovers and associated rail connectors

and fasteners at the job site, before getting started. For installa-

tions over 4x4 nominal wood posts, you will need (2) 2x4-pieces

of treated or cedar lumber per in-line rail postcover and (4) 2x4

pieces of treated or cedar lumber per corner rail postcover. The

length of the 2x4 depends on the height of the postcover. 42”

postcovers require 41" high 2x4s and the 53" requires 52"

high pieces.

A The deck design will dictate how you

install and secure the deck posts. Be

sure the post extends 41 inches above

the deck surface to ensure a proper ﬁt with

the 42" postcover and 52" above the deck

for a proper ﬁt with the 53" postcover.

B Posts should be installed on the inside

of the deck frame, to allow the postcover

to rest entirely on the decking.

Step 2 • Install postcover

C A 6x6 S4S (smooth four sides) wood

post can vary from 5-1/4" to 5-5/8"

in thickness and may be subject to

slight irregularities. Use wood shims

at the top and bottom of the post to

ensure a snug ﬁt. Shim the bottom

and slide the postcover over the post

to the deck base.

D Shim the top of the post for a tight,

level ﬁt. It is important to shim evenly

on all four sides so the post remains

centered within the postcover.

E If the installation is over a 4x4 nomi-

nal wood post, then wood 2x4s will

need to be added to the sides of the

4x4 post. The number of 2x4s differs

C D

Stacked Stone Cobblestone Fieldstone

In-line Rail Corner Rail

• Exterior masonry adhesive

(epoxy or silicone caulk)

• Wood shims

• Drill

• 1/8" Masonry drill bit

• Saw (if trimming is required)

• Diamond masonry blade

(if trimming is required)

• Carpenter’s pencil

based on the location of the wood

posts. You will need (2) 2x4-pieces

of lumber per in-line rail postcover

and (4) 2x4 pieces of lumber per

corner rail postcover. The length

of the 2x4 depends on the height

of the postcover. 42" postcovers

require 41" high 2x4’s and the 53"

requires 52" high pieces. For in-

line rail posts, attach the 2x4s to

the sides of the wood post where

the connector and railing will be

installed using 2-1/2" wood deck

screws. For corner posts, install

2x4s to all four sides of the post

using 2-1/2" wood deck screws.

Items you may need to complete the installation:

• 100 grit coarse aluminum

oxide sandpaper

• 2x4s as required

(see introduction section)

• 2-1/2" wood deck screws

as required

• #8 x 3-1/2" exterior grade

screws* (2 per rail bracket)

• Safety glasses

Step 1 • Secure 4x4 or 6x6 nominal treated or cedar wood posts

Note: Use a saw with a diamond masonry blade if trimming of the postcover is required.

Always trim the bottom of the postcover, which is the side without the lip.

1 2 3 4 5 6

Résumé du contenu

Page 1 - Step 2 • Install postcover

42” and 53” Postcover Installation InstructionsIntroductionCarefully plan your entire deck, from deck boards to rails and stairs, before cutting your

Page 2 - Postcover Installation

Postcover InstallationGIKJMHLG Before you install the rail connectors, you must ﬁrst mark the center of the postcover. To do this, make a vertical

Page 3

Instructions d’installation du capuchon de poteau de 42 et 53 poIntroductionPlaniﬁez avec soin toute votre terrasse, des éléments de planchers aux ram

Page 4 - Étape 6 • Fin du travail

Installation de capuchon de poteauGIKJMHLG Avant d’installer les raccords de rampe, vous devez d’abord marquer le centre du capuchon de poteau. Pour

Page 5 - Introducción

Instrucciones para la instalación de las cubiertas de poste de 42” y de 53”.IntroducciónPlanee cuidadosamente toda la terraza, desde las tablas de la

Page 6 - Paso 6 • Termine el trabajo

Instalación de cubierta para postesGIKJMHLG Antes de instalar los conectores de pasa-manos, primero debe encontrar el centro del poste en relación c

Commentaires sur ces manuels

Pas de commentaire

Deckorators Postcover Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la maison Deckorators Postcover. Deckorators Postcover User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Deckorators Postcover